cartoonbas.blogg.se - How do i manually set ip address for netgear router

I have been giving the task to replace about 11 Switches from Managed Cisco SGE Models to Managed Netgear S3300. Hello And thank you to anyone who is taking the time and reading my Post <3I have a weird problem, so bare with me.

No Internet Connection on Replaced Switch unless old Switch is also connected Networking.

Log into the verizon router at 192.168.1.1 and verify the DHCP scope is set to something above 192.168.1.2 for the start of the pool.ĭone! Now you can log into 192.168.1.1 to configure the Verizon router and 192.168.1.2 to configure the Netgear router! Flawless. Plug an ethernet cable from one of the LAN ports on the netgear to one of the LAN ports on your Verizon router and put a piece of tape over the WAN port on the netgear so you don't mistakenly plug something in there in the future.Ħ. Router reboots log back into it via 192.168.1.2 then disable DHCP. Router change it's LAN ip to 192.168.1.2.

With your computer plugged into one of the netgear routers LAN ports check what IP you get from the netgear router, if 192.168.1.x then open 192.168.1.1 in a web browser, if it's 192.168.0.x then use 192.168.0.1, etc. Unplug the netgear router from everything else except your computer.Ģ.

Some routers change their LAN ip when they detect a DHCP conflict, so it might not be 192.168.1.1 anymore! So check to see what IP your computer gets when you plug into it.ġ. Don't use wifi to configure the routers, plug an ethernet cable directly into one of the LAN ports, check what IP address you get, then go to x.x.x.1 and log into that router.Ĭonfigure the netgear router with it completely disconnected from everything else other than your computer.